Windshield Operation
Model CJ-2A,CJ-3A,CJ-3B : The entire windshield and frame assembly may be lowered down on top of the hood. This is accomplished by unlatching the retaining catches mounted on the cowl above the instrument panel. When lowered do not fail to strap it down with the strap provided which is mounted at the top of the radiator guard. On Model CJ-3A, when the windshield is in an upright position, ventilation is provided by a hinged ventilator mounted at the center of the panel directly under the windshield.
Windshield Weatherseals
On Models CJ-2A and CJ-3A, windshield weatherseals may be replaced as follows:
Open the windshield, swinging it up until it is parallel to the hood, and tighten the screws holding it in this position. Remove the old weatherseal and clean out the channel or groove thoroughly. Loading slots are provided in the vertical sides of the windshield frame at each corner to feed the new weatherseal into the channel. First lubricate the channel with either powdered graphite or brake fluid. Guard against over lubrication as the weatherseal will become coated, making it hard to handle. Feed the left lower end of the seal into the lower right end of the channel working it across the width of the windshield frame. Feed the two vertical ends into the vertical channels in the same manner and use a blunt tool to roll the corners of the seals into the corners of the channel. The flange of the seal is reduced in width at the corners to facilitate the installation.
Windshield Glass Replacement
Model CJ2A, CJ-3A
To replace the Models CJ-2A and CJ-3A windshield glass, follow the procedure outlined below:
a. Remove screws in each side of the windshield adjusting bracket at top.
b. Bend down lip on left hand outer end of hinge at top.
c. Open windshield sufficiently to clear the frame and slide assembly out of hinge to left.
d. Remove the nuts and bolts which hold the upper glass channel to frame.
e. Remove upper glass channel.
f. Withdraw glass from frame.
The installation of the glass is the reverse of the above operations. Use new tape around the glass.
Mechanical Manuals for your Willys.
If you are looking for, Willys Jeep Parts, Willys replacement parts, Willys body parts and much more for your 1941-1971 Willys vehicle, you have come to the right place! Don’t forget to check out our sister site, LiveOffroad, an online site dedicated to offering the lowest prices on parts and accessories for 1976+Up CJ & Wrangler! Live Well. Offroad Better.
when replacing the windshield on a CJ3A does the locking spline go on the inside or outside of the frame?
Hi Chad,
Please give Mike M. a call toll free at 1-888-648-4923 Mon-Fri 9AM-5PM EST or email mike@kaiserwillys.com and he will be happy to help!
Good Day. I have a 1961 Cj5 and have heard/read that if I get a 1971 cj5 windshield frame this would raise the glass and be a better fit for a taller person. Do you have any information regarding this.
Thanks for your time
Kind regards
Chad Lloyd
Hi Vivek, email mike@kaiserwillys.com your address and what parts you need. Mike will be more than happy to quote you on this! Have a great day!
hi
need to know if you have cj2a wind shield outer weather seals and glass beadings
what will be the approximate costs to have it sent to bangalore india /time fr shipments and duration
krgds
vivek